dyson-cli

Dyson CLI

Prerequisites

1. CLI installed at ~/dyson-cli with venv
2. Must be on same WiFi as the Dyson - local MQTT only, won't work remotely

Quick check:

cd ~/dyson-cli && source .venv/bin/activate && dyson list --check

Commands

Power

dyson on                      # Turn on
dyson off                     # Turn off

Fan Control

dyson fan speed 5             # Speed 1-10
dyson fan speed auto          # Auto mode
dyson fan oscillate on        # Enable oscillation
dyson fan oscillate on -a 90  # 90° sweep (45/90/180/350)
dyson fan oscillate off       # Disable oscillation

Heat Control (Hot+Cool models)

dyson heat on                 # Enable heating
dyson heat off                # Disable heating
dyson heat target 22          # Set target temp (°C)

Other

dyson night on                # Night mode on
dyson night off               # Night mode off
dyson status                  # Show current state
dyson status --json           # JSON output

Multiple Devices

Use -d <name> to target a specific device:

dyson on -d "Bedroom"
dyson fan speed auto -d "Office"

Common Patterns

# "Turn on the Dyson and set to auto"
dyson on && dyson fan speed auto

# "Heat to 23 degrees"
dyson heat on && dyson heat target 23

# "Turn on with gentle oscillation"
dyson on && dyson fan speed 3 && dyson fan oscillate on -a 45

# "What's the current temperature?"
dyson status --json | python3 -c "import sys,json; d=json.load(sys.stdin); print(f\"Temp: {d['temperature']-273:.1f}°C, Humidity: {d['humidity']}%\")"

Troubleshooting

If commands fail:

1. Check device is online: dyson list --check
2. Ensure on same WiFi network as the Dyson
3. Re-run setup if credentials expired: dyson setup

For installation, device setup, and full documentation, see README.md.